2 Bootstrap Validators that I like to use. https://jqueryvalidation.org/ http://1000hz.github.io/bootstrap-validator/
Category Archives: Programming
What are Deauth Attacks Used For?
This script will find the most powerful wifi interface and turn on monitor mode. If a monitor mode interface is already up it will use the first one it finds instead. It will then start sequentially hopping channels 1 per second from channel 1 to 11 identifying all access points and clients connected to those access points. On the first pass through all the wifi channels it is only identifying targets. After that the 1sec per channel time limit is eliminated and channels are hopped as soon as the deauth packets finish sending. Note that it will still add clients and APs as it finds them after the first pass through.
Upon hopping to a new channel it will identify targets that are on that channel and send 1 deauth packet to the client from the AP, 1 deauth to the AP from the client, and 1 deauth to the AP destined for the broadcast address to deauth all clients connected to the AP. Many APs ignore deauths to broadcast addresses.
# Console colors W = '\033[0m' # white (normal) R = '\033[31m' # red G = '\033[32m' # green O = '\033[33m' # orange B = '\033[34m' # blue P = '\033[35m' # purple C = '\033[36m' # cyan GR = '\033[37m' # gray T = '\033[93m' # tan
Set up terminal colors. Not perfect since some different terminal setups may break the colors but I can’t find a common setup that this doesn’t work with… yet.