HP Procurve Fan and Temps Sensors

https://kb.paessler.com/en/topic/73833-can-i-monitor-my-hp-procurve-switch-health
https://exchange.nagios.org/directory/Plugins/Hardware/Network-Gear/HP/HP-Procurve-SNMP-monitor/details

Setup
  1. Create a new SNMP Custom Advanced Sensor on the device
  2. Configure the channels like in the below table:
NameOIDValue TypeUnit / Lookup
CPU Load1.3.6.1.4.1.11.2.14.11.5.1.9.6.1.0GaugeCPU
Free Memory1.3.6.1.4.1.11.2.14.11.5.1.1.2.1.1.1.6.1GaugeBytes Memory
Fan State1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.1Gaugeprtg.customlookup.hp.procurve
Primary Power Supply State1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.2Gaugeprtg.customlookup.hp.procurve
Secondary Power Supply State1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.3Gaugeprtg.customlookup.hp.procurve
Temperature State1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.4Gaugeprtg.customlookup.hp.procurve
Average Temperature1.3.6.1.4.1.11.2.14.11.1.2.8.1.1.9.0GaugeTemperature


You’re done! Apply some limits to the CPU Load / Memory channel. It should look something like in the screenshot.

OID List

Parameter NameDescription
1.3.6.1.4.1.11.2.14.11.5.1.9.6.1.0The current CPU load in percent (integer)
1.3.6.1.4.1.11.2.14.11.5.1.1.2.1.1.1.6.1Free Memory in bytes
1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.1Current Fan State
1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.2Primary Power Supply State
1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.3Secondary Power Supply State
1.3.6.1.4.1.11.2.14.11.1.2.6.1.4.4Current Temperature State
1.3.6.1.4.1.11.2.14.11.1.2.8.1.1.9.0The average system temperature

State Table

StateDescription
1Invalid Value
3Bad
3Warning
4Good
5Not Present

Leave A Reply

Your email address will not be published. Required fields are marked *

 

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Bad Behavior has blocked 393 access attempts in the last 7 days.